Your browser does not allow storing cookies. We recommend enabling them.

SSH

SFTP and Tape Data Sets

When working with tape data sets, there are two alternative ways to specify the device unit on which the tape is to be mounted. Normally this can be done through the use of the FTADV/site parameter UNIT, but in some situations it is not practical to do so. The environment variable SSH_SFTP_VOL_UNIT_MAP can be defined to provide a mapping between a volume serial number pattern and a device unit, allowing the unit to be deduced from the volume.

SSH_SFTP_VOL_UNIT_MAP may be set to a picture-clause type pattern matching a six character volume serial number, and followed by the unit to be used, in the form SSH_SFTP_VOL_UNIT_MAP=volume_pattern:unit_specification.

For example, SSH_SFTP_VOL_UNIT_MAP=AA9999:CART, where A is an alphabetic character and 9 is a decimal digit, means that volumes with a serial number consisting of two letters followed by four digits are to be allocated with UNIT=CART.

More specifically, SSH_SFTP_VOL_UNIT_MAP=TP00001:CART generates an allocation request for a tape with volume serial number TP0001 with unit CART.


 

 
Highlights from the SSH.COM blog:

  • Cryptomining with the SSH protocol: what big enterprises need to know about it

    Cryptomining malware is primarily thought of as targeting desktops and laptops and is used to hijack system resources to mine cryptocurrency.
    Read more
  • SLAM the door shut on traditional privileged access management

    Did you know that something as trivial-sounding as granting access for your developers or third parties to a product development environment can throw a gorilla-sized monkey wrench into your operations and productivity?
    Read more
  • We broke the IT security perimeter

    Everyone understands the concept of a security perimeter. You only gain access if you are identified and authorized to do so.
    Read more