SSH Tectia 
PreviousNextUp[Contents] [Index]

    About This Document >>
    Installing SSH Tectia Server >>
        Planning the Installation >>
            System Requirements
            Licensing
            Upgrading the Installation
        Installing the SSH Tectia Server Software >>
        Removing the SSH Tectia Server Software >>
    Getting Started >>
    Configuration >>
    Authentication >>
    Application Tunneling >>
    Troubleshooting >>
    Man Pages
    Advanced Options >>
    Log Messages >>

System Requirements

The following operating systems are supported as SSH Tectia Server platforms:

  • IBM AIX 5.2 and 5.3 (POWER)
  • HP-UX 11.00, 11i v1 (11.11), and 11i v2 (11.23) (PA-RISC)
  • HP-UX 11i v1.6 (11.22) and 11i v2 (11.23) (IA64)
  • Red Hat Enterprise Linux 3 and 4 (x86)
  • SUSE LINUX Professional 9.0 and 9.1 (x86)
  • SUSE LINUX Enterprise Server 9 (x86)
  • Sun Solaris 8, 9, and 10 (SPARC)

The operating system is assumed to be installed with default components, unless otherwise mentioned.

On other Unix platforms than listed here, SSH Tectia Server can be installed by compiling from the source code. The source code is available separately upon request. See Appendix Installing on Other Unix Platforms.

The following minimum hardware is required:

  • SSH Tectia Server (A): For administration purposes, any standard hardware.

    SSH Tectia Server (T): 1 GB RAM for hundreds of simultaneous tunnels.

  • 100 MB free disk space
  • CD-ROM drive (optional, if installed from network)
  • TCP/IP connection

PreviousNextUp[Contents] [Index]


[ Contact Information | Support | Feedback | SSH Home Page | SSH Products ]

Copyright © 2010 SSH Communications Security Corp.
This software is protected by international copyright laws. All rights reserved.
Copyright Notice